Reinstalling the Fuel Tank

With the holes for the rudder springs drilled I was ready to start reassembly. First I vacuumed out the floor under the instrument panel and cleaned up the excess grease.

Next I put the fuel tank into place under the glare shield. This was much easier than removing it. I started to work at securing the tank straps. At this point I had a look at the plans and thought that I had forgotten to put felt onto the tank. I removed the tank and then remembered that there were special instructions for the root molded tank. I found the instructions on the Sonex website and sure enough, felt was not required. I repositioned the tank under the glare shield and proceeded to install and tighten the strap bolts. I had to remember to install the fuel tank cap and the drain valve in order to close up the tank and keep contaminates out.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.